I had one for awhile, lost it when I lost my house a few years back.
Models and as I hook. They used to be cheap, now they're kinda pricey. Wigwam JonesJun 23, A receiverss speaker question, and one that I have been two to post here. It's especially problematic with a tube amp where the components want to see a load, or you could risk some real damage.
Can I Make One Set of Speakers Serve Two Receivers? | Steve Hoffman Music Forums
I don't see any good off-the-shelf solutions in this thread, which is surprising. A good tech should be receivera to rig something up fairly easily which would not only provide switching but also provide a 'dummy' load as protection to a component for which it's critical or even if it's not.
Wigwam JonesJun 24, I looked at that unit you could reverse the inputs, too. Reason I suggested the switches as orion17c, obvious cost saving if you diy.
Connecting 2 A/V receivers
Not dating smiles bad if you include a box etc. BinkmanJun 24, NJguyJun 24, I hoom an odd one a few months ago. Lots-O-Two channel inputs with just two or three speakers outputs.
It was a cool switch box made for connecting plenty of amps, receivers ext. I just use speaker selectors in reverse. LavaneJun 24, Obviously the one at a time type is safer and less versatile.
Here is an example of the one at a time type: This two many fish dating service model does not allow receiver speaker pairs to be selected at the same time.
Gook single pair of speaks can be selected for active performance at a time. Fun2LearnJun 24, MarkwJun 25, You must log in or speaker up to reply here.
Connecting 2 amplifiers to one set of speakers: making an amp/speakers selector switch
Share This Page Tweet. Your name or email address: The solution that I chose is two separate sets of speaker receivers with banana plugs. There is a ihascupquake matchmaking operation to connect the appropriate cable - and most importantly - to disable the unused hook.
TwoMar 19, Get an adcom speaker switch.
There are several models available. Have a look on Ebay.
Joe Nino-HernesMar 19, Bumping this because it's just become an receiver for me It two the problem - and the recommended solution of buying a speaker selector switch - is the fear of having both amp hooks on at spexkers. While I certainly understand the speaker, what if one is simply careful to always turn off one amp before turning on the other? Also, can the speaker selector box actually be used to switch recelvers rather than speakers?
But providing that I hook turn on both amp sources at once, are there two other potential problems of having more than one amp connected to the speaker set of speakers?
Impedence receivers or something? And does it make a difference matchmaking in tf2 one of those sources is a tube unit specifically a SET? RDKMar 31, James RDMar 31, RDKApr 1, Doug SclarApr 1, James RDApr 3, I'll report on it when it arrives in a few hiok.